F3215-HP Load Balancing Module Network Management Command Reference-6PW101

435
Examples
# Display OSPFv3 virtual link information.
<Sysname> display ospfv3 vlink
Virtual Link VLINK1 to router 1.1.1.1 is up
Transit area :0.0.0.1 via interface GigabitEthernet0/1, instance ID: 0
Local address: 2000:1::1
Remote address: 2001:1:1::1
Transmit Delay is 1 sec, State: P-To-P,
Timer intervals configured, Hello: 10, Dead: 40, Wait: 40, Retransmit: 5
Hello due in 00:00:02
Adjacency state :Full
Table 112 Command output
Field Descri
p
tion
Virtual Link VLINK1 to router 1.1.1.1 is up The virtual link VLINK1 to router 1.1.1.1 is up.
Transit area 0.0.0.1 via interface GigabitEthernet0/1 Interface GigabitEthernet 0/1 in transit area 0.0.0.1.
instance ID Instance ID.
Local address Local IPv6 address.
Remote address Remote IPv6 address.
Transmit Delay Transmit delay of sending LSAs.
State Interface state.
Timer intervals configured, Hello: 10, Dead: 40,
Wait: 40, Retransmit: 5
Timer intervals in seconds:
• Hello—10.
• Dead—40.
• Wait—40.
• Retransmit—5.
Hello due in 00:00:02 Send hello packets in 2 seconds.
Adjacency state Adjacency state.
filter-policy export (OSPFv3 view)
Use filter-policy export to filter redistributed routes.
Use undo filter-policy export to remove the configuration.
Syntax
filter-policy { acl6-number | ipv6-prefix ipv6-prefix-name } export [ bgp4+ | direct | ospfv3 process-id
| ripng process-id | static ]
undo filter-policy export [ bgp4+ | direct | ospfv3 process-id | ripng process-id | static ]
Default
IPv6 OSPFv3 does not filter redistributed routes.
Views
OSPFv3 view