F3215-HP Load Balancing Module Network Management Command Reference-6PW101

548
Use undo apply preference to remove the clause configuration.
Syntax
apply preference preference
undo apply preference
Default
No preference is set for a routing protocol.
Views
Routing policy view
Default command level
2: System level
Parameters
preference: Routing protocol preference, in the range of 1 to 255.
Usage guidelines
If you have set preferences for routing protocols with the preference command, using the apply
preference command sets a new preference for the matching routing protocol. Non-matching routing
protocols still use the preferences set by the preference command.
Examples
# Configure node 10 in permit mode of routing policy policy1. Set the preference for OSPF external
routes to 90.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match route-type external-type1or2
[Sysname-route-policy] apply preference 90
apply preferred-value
Use apply preferred-value to set a preferred value for BGP routes.
Use undo apply preferred-value to remove the clause configuration.
Syntax
apply preferred-value preferred-value
undo apply preferred-value
Default
No preferred value is set for BGP routes.
Views
Routing policy view
Default command level
2: System level
Parameters
preferred-value: Preferred value, in the range of 0 to 65535.