F3215-HP Load Balancing Module Network Management Command Reference-6PW101

46
Examples
# Add a static entry for MAC address 000f-e201-0101 on port GigabitEthernet 0/1 that belongs to
VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] mac-address static 000f-e201-0101 vlan 2
Related commands
display mac-address
mac-address (system view)
Use mac-address to add or modify a MAC address entry.
Use undo mac-address to remove one or all MAC address entries.
Syntax
mac-address blackhole mac-address vlan vlan-id
mac-address { dynamic | static } mac-address interface interface-type interface-number vlan vlan-id
undo mac-address [ { dynamic | static } mac-address interface interface-type interface-number vlan
vlan-id ]
undo mac-address [ blackhole | dynamic | static ] [ mac-address ] vlan vlan-id
undo mac-address [ dynamic | static ] mac-address interface interface-type interface-number vlan
vlan-id
undo mac-address [ dynamic | static ] int
e
rface interface-type interface-number
Default
No MAC address entry is configured.
Views
System view
Default command level
2: System level
Parameters
blackhole: Specifies destination blackhole MAC address entries. These entries do not age, but you can
add or remove them. The packets whose destination MAC addresses match destination blackhole MAC
address entries are dropped.
mac-address: Specifies a MAC address in the format of H-H-H, where 0s at the beginning of each H
(16-bit hexadecimal digit) can be omitted. For example, entering "f-e2-1" indicates that the MAC address
is "000f-00e2-0001."
vlan vlan-id: Specifies an existing VLAN to which the Ethernet interface belongs, where vlan-id is the
specified VLAN ID, ranging from 1 to 4094.
dynamic: Specifies dynamic MAC address entries, which can be aged.
static: Specifies static MAC address entries. These entries do not age, but you can add or remove them.
interface interface-type interface-number: Specifies an outbound interface by its type and number.