F3215-HP Load Balancing Module Network Management Command Reference-6PW101

58
Field Descri
p
tion
Last clearing of counters
Time when the reset counters interface vlan-interface command was
last used to clear the interface statistics.
Never indicates the reset counters interface vlan-interface command
has never been used on the interface after the device's startup.
Last 5 seconds input: 0 bytes/sec 0
packets/sec
Average rate of input packets in the last 5 seconds (in bps and pps).
Last 5 seconds output: 0 bytes/sec 0
packets/sec
Average rate of output packets in the last 5 seconds (in bps and pps).
0 packets input, 0 bytes, 0 drops
Total number and size (in bytes) of the received packets of the interface
and the number of the dropped packets.
0 packets output, 0 bytes, 0 drops
Total number and size (in bytes) of the sent packets of the interface and
the number of the dropped packets.
The brief information of interface(s)
under route mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
Link layer state of an interface:
• ADM—The interface has been administratively shut down. To
recover its physical state, perform the undo shutdown command.
• Stby—The interface is operating as a standby interface. To see the
main interface, use the display standby state command.
Protocol: (s) - spoofing
If the network layer protocol state of an interface is shown as UP, but its
link is an on-demand link or not present at all, its protocol attribute
includes the spoofing flag (an s in parentheses).
Interface Abbreviated interface name.
Link
Physical link state of the interface:
• UP—The link is up.
• ADM—The link has been administratively shut down. To recover its
physical state, perform the undo shutdown command.
Protocol
Protocol connection state of the interface, which can be UP, DOWN,
or UP(s).
Main IP Main IP address of the interface.
Description Description of the interface.
Cause
Cause of a DOWN physical link. If the port has been shut down with
the shutdown command, this field displays Administratively. To restore
the physical state of the interface, use the undo shutdown command.
Related commands
reset counters interface vlan-interface
display vlan
Use display vlan to display VLAN information.
Syntax
display vlan [ vlan-id1 [ to vlan-id2 ] | all | dynamic | reserved | static ] [ | { begin | exclude | include }
regular-expression ]