F3215-HP Load Balancing Module Network Management Command Reference-6PW101

65
Syntax
vlan { vlan-id1 [ to vlan-id2 ] | all }
undo vlan { vlan-id1 [ to vlan-id2 ] | all }
Default
Only the default VLAN (VLAN 1) exists in the system.
Views
System view
Default command level
2: System level
Parameters
vlan-id1, vlan-id2: Specifies a VLAN ID, ranging from 1 to 4094.
vlan-id1 to vlan-id2: Specifies a VLAN range. vlan-id2 must be no smaller than vlan-id1.
all: Creates or removes all VLANs except reserved VLANs. The keyword is not supported when the
maximum number of VLANs that can be created on a device is less than 4094.
Usage guidelines
You cannot create or remove the default VLAN (VLAN 1).
You cannot create or remove VLANs reserved for specific functions.
Examples
# Create VLAN 2, and enter VLAN 2 view.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2]
# Create VLAN 4 through VLAN 100.
<Sysname> system-view
[Sysname] vlan 4 to 100
Please wait............. Done.
Related commands
display vlan
Port-based VLAN configuration commands
display port
Use display port to display information about the hybrid or trunk ports on the device, including the port
names, PVIDs, and allowed VLAN IDs.
Syntax
display port { hybrid | trunk } [ | { begin | exclude | include } regular-expression ]
Views
Any view