F3215-HP Load Balancing Module Network Management Command Reference-6PW101

68
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] port access vlan 3
port hybrid pvid
Use port hybrid pvid to configure the PVID of the hybrid port.
Use undo port hybrid pvid to restore the default.
Syntax
port hybrid pvid vlan vlan-id
undo port hybrid pvid
Default
The PVID of a hybrid port is VLAN 1.
Views
Ethernet interface view
Default command level
2: System level
Parameters
vlan-id: Specifies a VLAN ID, ranging from 1 to 4094.
Usage guidelines
You can use a nonexistent VLAN as the PVID for a hybrid port. If you use the undo vlan command to
remove the PVID of a hybrid port, it does not affect the setting of the PVID on the port.
HP recommends that you set the same PVID for the local and remote hybrid ports.
You must use the port hybrid vlan command to configure the hybrid port to permit the packets from the
PVID to pass through.
Examples
# Configure VLAN 100 as the PVID of the hybrid port GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] vlan 100
[Sysname-vlan100] quit
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] port link-type hybrid
[Sysname-GigabitEthernet0/1] port hybrid pvid vlan 100
Related commands
• port hybrid vlan
• port link-type
port hybrid vlan
Use port hybrid vlan to assign the hybrid ports to the specified VLANs.