F3215-HP Load Balancing Module Network Management Command Reference-6PW101

78
# Assign access port GigabitEthernet 0/1 to VLAN 10, which is not an isolate-user-VLAN, configure the
port to operate in promiscuous mode in VLAN 10, and then cancel the configuration.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] display this
#
interface GigabitEthernet0/1
port link-mode bridge
#
return
[Sysname-GigabitEthernet0/1] port isolate-user-vlan 10 promiscuous
[Sysname-GigabitEthernet0/1] display this
#
interface GigabitEthernet0/1
port link-mode bridge
port isolate-user-vlan 10 promiscuous
port access vlan 10
#
return
[Sysname-GigabitEthernet0/1] undo port isolate-user-vlan
[Sysname-GigabitEthernet0/1] display this
#
interface GigabitEthernet0/1
port link-mode bridge
port access vlan 10
#
return
port isolate-user-vlan host
Use port isolate-user-vlan host to configure a port to operate in host mode. If the port has been assigned
to a secondary VLAN, the command also assigns the port to the isolate-user-VLAN that is associated with
the secondary VLAN.
Use undo port isolate-user-vlan to cancel the host operating mode of a port.
Syntax
port isolate-user-vlan host
undo port isolate-user-vlan
Default
A port does not operate in host mode.
Views
Layer 2 Ethernet interface view
Default command level
2: System level
Usage guidelines
When the device executes the port isolate-user-vlan host command, the following guidelines apply: