F3215-HP Load Balancing Module Network Management Command Reference-6PW101

81
undo arp ip-address
Views
System view
Default command level
2: System level
Parameters
ip-address: IP address in an ARP entry.
mac-address: MAC address in an ARP entry, in the format H-H-H.
vlan-id: ID of a VLAN to which a static ARP entry belongs, in the range of 1 to 4094.
interface-type interface-number: Interface type and interface number.
Usage guidelines
A static ARP entry is effective when the device works normally. However, when the VLAN or VLAN
interface to which an ARP entry corresponds is deleted, the entry, if long, is deleted, and if short and
resolved, becomes unresolved.
The vlan-id argument specifies the VLAN corresponding to an ARP entry and must be the ID of an existing
VLAN. In addition, the Ethernet interface following the argument must belong to that VLAN. The VLAN
interface of the VLAN must have been created.
If both the vlan-id and ip-address arguments are specified, the IP address of the VLAN interface
corresponding to the vlan-id argument must be in the same network segment as the IP address specified
by the ip-address argument.
Examples
# Configure a static ARP entry with IP address 202.38.10.2, MAC address 00e0-fc01-0000, and
outbound interface GigabitEthernet 0/1 of VLAN 10.
<Sysname> system-view
[Sysname] arp static 202.38.10.2 00e0-fc01-0000 10 gigabitethernet 0/1
Related commands
• reset arp
• display arp
arp timer aging
Use arp timer aging to set the aging timer for dynamic ARP entries.
Use undo arp timer aging to restore the default.
Syntax
arp timer aging aging-time
undo arp timer aging
Default
The aging timer for dynamic ARP entries is 20 minutes.
Views
System view