F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

89
Ste
p
Command Remarks
4. Enter the view of the
ten-GigabitEthernet
interface that connects to the
switch.
interface Ten-GigabitEthernet
interface-number
N/A
5. Configure the operating
mode of the interface as
Layer 2.
port link-mode bridge
The default operating mode is
Layer 3.
6. Configure the link type of the
ten-GigabitEthernet
interface as trunk.
port link-type trunk N/A
7. Assign the trunk port to the
specified VLANs.
port trunk permit vlan { vlan-id-list |
all }
The VLANs of the LB module and
the VLANs on the switch must be
included.
8. Create a VLAN interface
and enter its view.
interface vlan-interface
vlan-interface-id
The vlan-interface-id must be one of
the VLAN IDs created on the switch.
9. Assign an IP address to the
VLAN interface.
ip address ip-address { mask |
mask-length } [ sub ]
By default, the VLAN interface has
no IP address.
10. Create another VLAN
interface and enter its view.
interface vlan-interface
vlan-interface-id
The vlan-interface-id must be the ID
of the other VLAN created on the
switch.
11. Assign an IP address to the
VLAN interface.
ip address ip-address { mask |
mask-length } [ sub ]
By default, the VLAN interface has
no IP address.
Displaying and maintaining inter-VLAN Layer 3 forwarding
Task Command Remarks
Display brief interface
information.
display brief interface [ interface-type
[ interface-number |
interface-number.subnumber ] ] [ | { begin |
include | exclude } text ]
Available in any view.
Display
interface/subinterface state
and related information.
display interface [ interface-type [interface-number
| interface-number.subnumber ] ]
Available in any view.
Clear interface/subinterface
statistics.
reset counters interface [ interface-type
[ interface-number |
interface-number.subnumber ] ]
Available in user view.
Display VLAN information.
display vlan [ vlan-id1 [ to vlan-id2 ] | all |
dynamic | interface interface-type
interface-number.subnumber | reserved | static ]
Available in any view.