F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

[LB-Ten-GigabitEthernet0/0.1] ip address 102.0.0.3 24

[LB-Ten-GigabitEthernet0/0.1] interface ten-gigabitethernet0/0.2

[LB-Ten-GigabitEthernet0/0.2] vlan-type dot1q vid 103

[LB-Ten-GigabitEthernet0/0.2] ip address 103.0.0.3 24

Inter-VLAN Layer 3 forwarding configuration

example

Network requirements

As shown in Figure 51, traffic between GigabitEthernet 3/0/1 and GigabitEthernet 3/0/2 is filtered by

an LB module, and inter-VLAN Layer 3 forwarding needs to be configured.

Figure 51 Network diagram for inter-VLAN Layer 3 forwarding

Configuration procedure

• Configure the ports on the switch:

# Create VLAN 102 and VLAN 103. Assign GigabitEthernet 3/0/1 to VLAN 102 and

GigabitEthernet 3/0/2 to VLAN 103.

<Switch> system-view

[Switch] vlan 102

[Switch-vlan102] port gigabitethernet 3/0/1

[Switch-vlan102] vlan 103

[Switch-vlan103] port gigabitethernet 3/0/2

[Switch-vlan103] quit

# Configure the link type of ten-GigabitEthernet 2/0/1 as trunk. Assign the port to VLAN 102 and

VLAN 103.

[Switch] interface ten-gigabitethernet 2/0/1

[Switch-Ten-GigabitEthernet2/0/1] port link-type trunk

[Switch-Ten-GigabitEthernet2/0/1] port trunk permit vlan 102 103

• Configure the LB module:

# Create VLAN 102 and VLAN 103.

<LB> system-view

LB module

Switch or Router

XGE2/0/1

XGE0/0

GE3/0/1

IP network IP network

GE3/0/2