F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

102
2. In the Static Address Mapping area where static address mappings are displayed, click Add to
enter the Add Static Address Mapping page.
Figure 60 Adding Static Address Mapping page
3. Configure a static address mapping as described in Table 9.
4. Click Apply.
Table 9 Configuration item
Item Descri
p
tion
Internal VPN Instance
Specify a name of the VPN instance to which the internal IP addresses belong.
If no internal VPN instance is specified, this indicates that the internal address is
a common private network address.
Internal IP Address Enter an internal IP address for the static address mapping.
Global VPN Instance
Specify a name of the VPN instance to which the external IP addresses belong.
If no global VPN instance is specified, this indicates that the external address is
a common public network address.
Global IP Address Enter a public IP address for the static address mapping.
Network Mask
Specify the network mask for internal and public IP addresses.
If the network mask is specified, net-to-net static NAT is implemented. If no
network mask is specified, the default mask 255.255.255.255 is used. In this
case, one-to-one static NAT is delivered.
ACL Enter the number of an ACL for the static NAT policy.
Enabling static NAT on an interface
1. From the navigation tree, select Security > NAT, and click the Static NAT tab.
2. In the Interface Static Translation area, click Add to enter the Enable Interface Static Translation
page.