F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

133
Figure 83 Network diagram
Configuration procedure
1. Configure LB (NAT-PT device):
# Configure interface addresses and enable NAT-PT on the interfaces.
<LB> system-view
[LB] ipv6
[LB] interface gigabitethernet 0/1
[LB-GigabitEthernet0/1] ip address 8.0.0.1 255.255.255.0
[LB-GigabitEthernet0/1] natpt enable
[LB-GigabitEthernet0/1] quit
[LB] interface gigabitethernet 0/2
[LB-GigabitEthernet0/2] ipv6 address 2001::1/64
[LB-GigabitEthernet0/2] natpt enable
[LB-GigabitEthernet0/2] quit
# Configure a NAT-PT prefix.
[LB] natpt prefix 3001::
# Configure a NAT-PT address pool.
[LB] natpt address-group 1 9.0.0.10 9.0.0.19
# Associate the prefix with the address pool for IPv6 hosts accessing IPv4 hosts.
[LB] natpt v6bound dynamic prefix 3001:: address-group 1
2. Configure Router A on the IPv4 side:
# Configure an IP address for GigabitEthernet 0/1.
<RouterA> system-view
[RouterA] interface gigabitethernet 0/1
[RouterA-GigabitEthernet0/1] ip address 8.0.0.2 255.255.255.0
[RouterA-GigabitEthernet0/1] quit
# Configure a static route to subnet 9.0.0.0/24.
[RouterA] ip route-static 9.0.0.0 24 8.0.0.1
3. Configure Router B on the IPv6 side:
# Enable IPv6.
<RouterB> system-view
[RouterB] ipv6
# Configure an IP address for Serial 2/0.
[RouterB] interface gigabitethernet 0/1
[RouterB-GigabitEthernet0/1] ipv6 address 2001::2/64
[RouterB-GigabitEthernet0/1] quit
# Configure a static route to the subnet with the NAT-PT prefix.
[RouterB] ipv6 route-static 3001:: 16 2001::1