F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

147
Figure 93 Creating a static domain name resolution entry
3. Type the name and IP address. (Each name corresponds to one IP address only. If you configure
multiple IP addresses for a host name, the one last configured takes effect.)
4. Click Apply.
Configuring dynamic domain name resolution
NOTE:
The device can revolve a maximum of four IP addresses for a domain name.
1. From the navigation tree, select Network > DNS, and click the Dynamic tab.
The dynamic domain name resolution configuration page appears, as shown in Figure 94.
2. Select the Enable option for Dynamic DNS.
3. Click Apply.
Figure 94 Dynamic domain name resolution configuration page