F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

163
Configuring static routing
Static routes are manually configured. If a network's topology is simple, you only need to configure static
routes for the network to work properly.
Static routes cannot adapt to network topology changes. If a fault or a topological change occurs in the
network, the network administrator must modify the static routes manually.
The term "router" in this document refers to both routers and LB modules.
Configuring static routing in the Web interface
Configuring static routes
1. Select Network > Static Routing from the navigation tree.
The static route configuration page appears.
Figure 110 Static route configuration page
2. Click Add.
The page for configuring a static route appears.
Figure 111 Creating a static route
3. Create a static route as described in Table 15.
4. Click Apply.