F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

164
Table 15 Configuration items
Item Descri
p
tion
Destination IP Address
Enter the destination IP address in
dotted decimal notation.
IMPORTANT:
You can enter 0.0.0.0 for both
Destination IP Address and Mask to
configure a default route. A default route
is used to forward packets that match no
route entry in the routing table.
Mask Enter the destination IP address mask.
Next Hop Enter the next hop IP address in dotted decimal notation.
Outbound Interface Enter the outbound interface.
Priority
Enter the static route priority.
The static route priority defaults to 60.
Static route configuration example
In this example, Device A is the LB module.
Network requirements
Configure IP addresses and masks for the interfaces and hosts as shown in Figure 112. Configure static
routes between the hosts so that any two hosts can communicate with each other.
Figure 112 Network diagram
Configuration procedure
1. Configure the IP addresses of the hosts, and configure the default gateways of Host A, Host B and
Host C as 1.1.2.3, 1.1.6.1 and 1.1.3.1. (Details not shown.)
2. Configure IP addresses for interfaces. (Details not shown.)
3. Configure a static route to Device B on Device A:
a. Select Network > Static Routing from the navigation tree.
b. Click Add.
The page for configuring a static route appears.