Manualshelf

F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

ManualsBrandsHP ManualsComputer AccessoriesHP 7100/7200 IPsec dl Module
171172173174175176177178179180
165
c. Enter 0.0.0.0 as the destination IP address, select 0.0.0.0 from the mask list, and enter 1.1.4.2
as the next hop.
d. Click Apply.
Figure 113 Configuring a static route on Device A
4. Configure a static route to Device A and a static route to Device C on Device B:
a. Select Network > Static Routing from the navigation tree.
b. Click Add.
c. Enter 1.1.2.0 as the destination IP address, select 255.255.255.0 from the mask list, and enter
1.1.4.1 as the next hop.
d. Click Apply.
e. Click Add.
f. Enter 1.1.3.0 as the destination IP address, select 255.255.255.0 from the mask list, and enter
1.1.5.6 as the next hop.
g. Click Apply.
5. Configure a static route to Device B on Device C:
a. Select Network > Static Routing from the navigation tree.
b. Click Add.
c. Enter 0.0.0.0 as the destination IP address, select 0.0.0.0 from the mask list, and enter 1.1.5.5
as the next hop.
d. Click Apply.
Verifying the configuration
1. Ping Host A on Host B (suppose the host runs Windows XP):
C:\Documents and Settings\Administrator>ping 1.1.2.2
Pinging 1.1.2.2 with 32 bytes of data:
Reply from 1.1.2.2: bytes=32 time=1ms TTL=128
Reply from 1.1.2.2: bytes=32 time=1ms TTL=128
Reply from 1.1.2.2: bytes=32 time=1ms TTL=128
Reply from 1.1.2.2: bytes=32 time=1ms TTL=128