F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

173
Figure 117 RIP interface configuration page
4. Configure RIP interface as described in Table 17.
5. Click Apply.
Table 17 Configuration items
Item Descri
p
tion
Interface Displays the RIP interface name.
Work State
Set whether to allow the receiving/sending of RIP packets on the interface:
• On—Allows the receiving/sending of RIP packets on the interface.
• Off—Disallows the receiving/sending of RIP packets on the interface.
Version
Specify a RIP version for the interface:
• Default—The interface can send RIPv1 broadcasts and can receive RIPv1 broadcast
and unicast packets, and RIPv2 broadcast, multicast, and unicast packets.
• RIPv1—The interface can send RIPv1 broadcasts, and can receive RIPv1 broadcasts
and RIPv1 unicasts.
• RIPv2—The interface can send RIPv2 multicasts and can receive RIPv2 unicasts,
broadcasts and multicasts.
• RIPv2 broadcast—The interface can send RIPv2 broadcasts and can receive RIPv1
unicasts, and broadcasts, and RIPv2 broadcasts, multicasts and unicasts.
Authentication Mode
Set the authentication mode and parameters for authenticating RIP packets on a RIPv2
interface:
• If the Authentication Mode is null, the interface does not authenticate RIP packets,
and the Key String and Key ID are not required.
• If Simple is specified for Authentication Mode, the interface authenticates RIP
packets using simple text key. You need to configure a Key String in simple text.
• If MD5 RFC2453 is specified for Authentication Mode, the interface adopts the MD5
authentication mode, and the authentication packet is in the format defined in RFC
2453. You need to configure a Key String in MD5 cipher text.
• If MD5 RFC2082 is specified for Authentication Mode, the interface adopts the MD5
authentication mode, and the authentication packet is in the format defined in RFC
2082. Then, you need to configure a Key String in MD5 cipher text and a Key ID.
IMPORTANT:
If Default or RIPv1 is specified as the RIP version, the authentication information you have
configured does not take effect.
Key String
Key ID