F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

6
Figure 4 Modifying interface information
3. Modify the interface as described in Table 2 and Table 1.
4. Click Apply.
Table 2 Configuration items
Item Descri
p
tion
Interface Type Set the interface type, which can be Electrical port, Optical port, or None.
Interface Status
Display and set the interface status:
• Connected—Indicates that the current interface is up and connected, click the
Disable button to shut down the interface.
• Not connected—Indicates that the current interface is up, but not connected,
click the Disable button to shut down the interface.
• Administratively Down—Indicates that the current interface is shut down by a
network administrator, click the Enable button to bring up the interface.
After you click the Enable/Disable button, the page displaying interface
information appears automatically.
For an interface whose status cannot be changed, the Enable/Disable button is not
available.
Working Mode
Configure the interface to operate in bridge mode or router mode.
A loopback interface operates only in router mode.
Before configuring an IP address for the interface, make sure the interface is
configured to operate in router mode.