F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

179
To enable RIPv2 automatic route summarization:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ]
[ vpn-instance
vpn-instance-name ]
N/A
3. Enable RIPv2 automatic route
summarization.
summary
Optional.
By default, RIPv2 automatic route
summarization is enabled.
If the subnets in the routing table are not
contiguous, disable automatic route
summarization to advertise more specific
routes.
2. Advertising a summary route
Perform this task to manually configure a summary route.
For example, suppose contiguous subnets routes 10.1.1.0/24, 10.1.2.0/24, and 10.1.3.0/24 exist in the
routing table. You can create a summary route 10.1.0.0/16 on GigabitEthernet 0/1 to advertise the
summary route instead of the more specific routes.
To configure a summary route:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Disable RIPv2 automatic route
summarization.
undo summary
By default, RIPv2 automatic route
summarization is enabled.
4. Return to system view. quit N/A
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Configure a summary route.
rip summary-address ip-address
{ mask | mask-length }
N/A
Disabling host route reception
Perform this task to disable RIPv2 from receiving host routes from the same network and save network
resources. This feature does not apply to RIPv1.
To disable RIP from receiving host routes:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A