F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

185
Ste
p
Command Remarks
4. Disable source address check
on incoming RIP updates.
undo validate-source-address
By default, this function is not
disabled.
Configuring RIP-to-MIB binding
This task allows you to enable a specific RIP process to receive SNMP requests.
To bind RIP to MIB:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Bind RIP to MIB. rip mib-binding process-id
Optional.
By default, MIB is bound to RIP
process 1.
Configuring the RIP packet sending rate
Perform this task to specify the interval for sending RIP packets and the maximum number of RIP packets
that can be sent at each interval. This feature can avoid excessive RIP packets from affecting system
performance and consuming too much bandwidth.
To configure the RIP packet sending rate:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify the interval for
sending RIP packets and the
maximum number of RIP
packets that can be sent at
each interval.
output-delay time count count
Optional.
By default, an interface sends up to
three RIP packets every 20
milliseconds.
Displaying and maintaining RIP
Task Command Remarks
Display RIP current status and
configuration information.
display rip [ process-id |
vpn-instance vpn-instance-name ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display all active routes in RIP
database.
display rip process-id database [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Display RIP interface information.
display rip process-id interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view.