F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

188
• Configure basic RIP:
# Enable RIP 100, and configure RIPv2 on Router A.
<RouterA> system-view
[RouterA] rip 100
[RouterA-rip-100] network 10.0.0.0
[RouterA-rip-100] network 11.0.0.0
[RouterA-rip-100] version 2
[RouterA-rip-100] undo summary
[RouterA-rip-100] quit
# Enable RIP 100 and RIP 200, and configure RIPv2 on LB.
<LB> system-view
[LB] rip 100
[LB-rip-100] network 11.0.0.0
[LB-rip-100] version 2
[LB-rip-100] undo summary
[LB-rip-100] quit
[LB] rip 200
[LB-rip-200] network 12.0.0.0
[LB-rip-200] version 2
[LB-rip-200] undo summary
[LB-rip-200] quit
# Enable RIP 200 and configure RIPv2 on Router B.
<RouterB> system-view
[RouterB] rip 200
[RouterB-rip-200] network 12.0.0.0
[RouterB-rip-200] network 16.0.0.0
[RouterB-rip-200] version 2
[RouterB-rip-200] undo summary
[RouterB-rip-200] quit
# Display the IP routing table on Router B.
[RouterB] display ip routing-table
Routing Tables: Public
Destinations : 6 Routes : 6
Destination/Mask Proto Pre Cost NextHop Interface
12.3.1.0/24 Direct 0 0 12.3.1.2 GE0/1
12.3.1.2/32 Direct 0 0 127.0.0.1 InLoop0
16.4.1.0/24 Direct 0 0 16.4.1.1 GE0/2
16.4.1.1/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
• Configure RIP route redistribution:
# Configure RIP 200 to redistribute direct routes and routes from RIP 100 on LB.
[LB] rip 200
[LB-rip-200] import-route rip 100
[LB-rip-200] import-route direct
[LB-rip-200] quit