F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

220
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Configure the default
parameters for
redistributed routes (cost,
upper limit, tag, and
type).
default { cost cost | limit limit | tag tag | type
type } *
Optional.
The default cost is 1, the
default maximum number
of routes redistributed per
time is 1000, the default
tag is 1, and default type
of redistributed routes is
Type-2.
Advertising a host route
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
N/A
3. Enter area view.
area area-id
N/A
4. Advertise a host route. host-advertise ip-address cost Not advertised by default.
Tuning and optimizing OSPF networks
You can optimize an OSPF network in the following ways:
• Change OSPF packet timers to adjust the convergence speed and network load. On low-speed
links, consider the delay time for sending LSAs.
• Change the SPF calculation interval to reduce resource consumption caused by frequent network
changes.
• Configure OSPF authentication to improve security.
Configuration prerequisites
Before you configure OSPF network optimization, complete the following tasks:
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring nodes.
• Enable OSPF.
Configuring OSPF packet timers
You can configure the following timers on OSPF interfaces as needed.
• Hello timer—Interval for sending hello packets. It must be identical on OSPF neighbors.
• Poll timer—Interval for sending hello packets to a neighbor that is down on the NBMA network. The
poll interval is at least four times the hello interval.
• Dead timer—Interval within which if the interface receives no hello packet from the neighbor, it
declares the neighbor is down. The dead interval must be at least four times the hello interval on an
interface.