F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101
226
The generated traps are sent to the information center of the device. The output rules of the traps (whether
to output the traps and the output direction) are determined according to the information center
configuration. (For more information about information center, see System Maintenance Configuration
Guide.)
To configure OSPF network management:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Bind OSPF MIB to an
OSPF process.
ospf mib-binding process-id
Optional.
The OSPF process with the smallest
process-id is bound with OSPF MIB
by default.
3. Enable OSPF trap
generation.
snmp-agent trap enable ospf [ process-id ]
[ ifauthfail | ifcfgerror | ifrxbadpkt |
ifstatechange | iftxretransmit |
lsdbapproachoverflow | lsdboverflow |
maxagelsa | nbrstatechange | originatelsa
| vifcfgerror | virifauthfail | virifrxbadpkt
| virifstatechange | viriftxretransmit |
virnbrstatechange ] *
Optional.
Enabled by default.
Enabling message logging
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Enable message
logging.
enable log [ config | error | state ]
By default, the function is
disabled.
Enabling the advertisement and reception of opaque LSAs
With this feature enabled, OSPF can receive and advertise Type 9, Type 10, and Type 11 opaque LSAs.
To enable the advertisement and reception of opaque LSAs:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Enable the advertisement and
reception of opaque LSAs.
opaque-capability enable
Optional.
By default, the
function is disabled.
Configuring OSPF to give priority to receiving and processing hello packets
To ensure OSPF runs properly, a router receives and processes hello packets and other protocol packets
at the same time. When the router has established neighbor relationships with multiple routers, and the
routing table size is big, the router must receive and process large numbers of packets. In this case, you