F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

11
Figure 9 Displaying interface statistics
6. Shut down interface GigabitEthernet 0/1:
a. Click Back on the Port Statistics page.
b. Click the icon for GigabitEthernet0/1.
c. Click Disable at the end of the Interface Status line.
GigabitEthernet 0/1 is shut down, and Host A cannot access LB.
Managing interfaces at the CLI
Performing general configurations
This section describes the settings common to Layer 2 and Layer 3 Ethernet interfaces or subinterfaces.
For more information about the settings specific to a type of Ethernet interfaces, see "Configuring a Layer
2 Ethernet i
nterface or subinterface" and "Configuring a Layer 3 Ethernet interface or subinterface."
Configuring a combo interface
A combo interface is a logical interface that comprises one fiber port and one copper port. The two ports
share one forwarding channel and one interface view, so they cannot work simultaneously. When you
enable one port, the other port is automatically disabled.