F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

227
can configure OSPF to give priority to receiving and processing Hello packets to ensure stable neighbor
relationships.
To configure OSPF to give priority to receiving and processing Hello packets:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure OSPF to give priority
to receiving and processing
hello packets.
ospf packet-process
prioritized-treatment
Not configured by default.
Configuring the LSU transmit rate
Sending large numbers of LSU packets affects router performance and consumes too much network
bandwidth. You can configure the router to send LSU packets at a proper interval and limit the maximum
number of LSU packets sent out of an OSPF interface each time.
To configure the LSU transmit rate:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Configure the LSU
transmit rate.
transmit-pacing interval interval count count
Optional.
By default, an OSPF interface
sends up to three LSU packets
every 20 milliseconds.
Enabling OSPF ISPF
Upon topology changes, Incremental Shortest Path First (ISPF) computes only the affected part of the SPT,
instead of the entire SPT.
To enable OSPF ISPF:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Enable OSPF ISPF.
ispf enable
Optional.
By default, OSPF ISPF is
disabled.
Displaying and maintaining OSPF
Task Command Remarks
Display OSPF brief information.
display ospf [ process-id ] brief [ | { begin |
exclude | include } regular-expression ]
Available in any
view.