F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

229
Task Command Remarks
Re-enable OSPF route
redistribution.
reset ospf [ process-id ] redistribution
Available in user
view.
OSPF configuration examples
These configuration examples only cover OSPF configuration related commands.
Configuring basic OSPF
1. Network requirements
• Enable OSPF on all devices, and split the AS into three areas.
• Configure Router A and Router B as ABRs.
Figure 141 Network diagram
2. Configuration procedure
a. Configure IP addresses for interfaces. (Details not shown.)
b. Configure basic OSPF:
# Configure Router A.
<RouterA> system-view
[RouterA] ospf
[RouterA-ospf-1] area 0
[RouterA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.0] quit
[RouterA-ospf-1] area 1
[RouterA-ospf-1-area-0.0.0.1] network 10.2.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.1] quit
[RouterA-ospf-1] quit
# Configure Router B.
<RouterB> system-view
[RouterB] ospf
[RouterB-ospf-1] area 0
[RouterB-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] quit
[RouterB-ospf-1] area 2
[RouterB-ospf-1-area-0.0.0.2] network 10.3.1.0 0.0.0.255