F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

13
Ste
p
Command Remarks
3. Set the interface
description.
description text
Optional.
By default, the description of an interface is
in the format of interface-name Interface.
For example, GigabitEthernet0/1
Interface.
4. Set the duplex mode of
the interface.
duplex { auto | full | half }
Optional.
By default, the duplex mode is auto for
other Ethernet interfaces.
Fiber ports do not support the half
keyword.
5. Set the port speed.
speed { 10 | 100 | 1000 |
auto }
Optional.
The default setting is auto.
6. Restore the default
settings for the interface.
default Optional.
2. Configuring an Ethernet subinterface
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Create an Ethernet
subinterface.
interface interface-type
interface-number.subnumber
This command also leads you to
Ethernet subinterface view.
3. Set the interface description.
description text
Optional.
By default, the description of an
Ethernet subinterface is in the
format of interface-name Interface.
For example,
GigabitEthernet0/1.1 Interface.
4. Restore the default settings for
the subinterface.
default Optional.
You can configure IP-related settings on an Ethernet subinterface.
For the local and remote Ethernet subinterfaces to transmit traffic correctly, assign them to the same
VLAN.
Shutting down an Ethernet interface or subinterface
CAUTION:
Use this command with caution. After you manually shut down an Ethernet interface, the Ethernet interface
cannot forward packets even if it is physically connected.
You might need to shut down and then bring up an Ethernet interface or subinterface to activate some
configuration changes, for example, the speed or duplex mode changes.
To shut down an Ethernet interface or subinterface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A