F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

253
BGP configuration example
In this example, Device A is the LB module.
Network requirements
In the following figure are all BGP devices. Between Device A and Device B is an EBGP connection. IBGP
speakers Device B, Device C, and Device D are fully meshed.
Figure 153 Network diagram
Configuring Device A
1. Configure IP addresses for interfaces. (Details not shown.)
2. Enable BGP:
d. Select Network > BGP from the navigation tree of Device B.
The BGP configuration page appears.
Figure 154 Enabling BGP