F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

256
e. Enter 9.1.2.1 for Peer IP Address and 65009 for Peer AS.
f. Click Apply.
Verifying the configuration
1. Select Network > BGP from the navigation tree of Device B.
2. Click Show Peer in the Show Information field.
BGP connections are established from Device B to other devices.
Figure 157 BGP configuration result
Configuring BGP at the CLI
BGP configuration task list
In a basic BGP network, you only need to perform the following configurations:
• Enable BGP.
• Configure BGP peers or peer groups.
• Control BGP route generation.
To control BGP route distribution and path selection, you must perform other configurations.
If you configure a BGP setting for a peer group and a peer in the group, the last configuration takes
effect.
Complete the following tasks to configure BGP:
Task Remarks
Configuring basic BGP
Enabling BGP Required.
Configuring a BGP peer Required.
HP recommends
configuring BGP peer
groups on large scale BGP
networks for easy
configuration and
maintenance.
Configuring a BGP peer group
Specifying the source interface for TCP
connections
Optional.
Generating BGP routes
Injecting a local network
Required.
Use at least one approach.
Redistributing IGP routes