F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

322
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter policy node view.
policy-based-route policy-name [ deny |
permit ] node node-number
N/A
3. Configure an ACL match
criterion.
if-match acl acl-number Optional.
4. Configure a packet length
match criterion.
if-match packet-length min-len max-len Optional.
5. Configure a reverse input
interface match criterion.
if-match reverse-input-interface interface-type
interface-number
Optional.
Configuring actions for a node
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter policy node view.
policy-based-route policy-name
[ deny | permit ] node
node-number
N/A
3. Set VPN instances.
apply access-vpn vpn-instance
vpn-instance-name&<1-6>
Optional.
4. Set an IP precedence.
apply ip-precedence value Optional.
5. Set output interfaces.
apply output-interface
interface-type interface-number
[ track track-entry-number ]
[ interface-type interface-number
[ track track-entry-number ] ]
Optional.
You can specify up to two output
interfaces to achieve load sharing.
6. Set next hops.
apply ip-address next-hop
ip-address [ direct ] [ track
track-entry-number ] [ ip-address
[ direct ] [ track
track-entry-number ] ]
Optional.
You can specify up to two next
hops to achieve load sharing.
7. Set default output interfaces.
apply default output-interface
interface-type interface-number
[ track track-entry-number ]
[ interface-type interface-number
[ track track-entry-number ] ]
Optional.
You can specify up to two default
output interfaces to achieve load
sharing.
8. Set default next hops.
apply ip-address default next-hop
ip-address [ track
track-entry-number ] [ ip-address
[ track track-entry-number ] ]
Optional.
You can specify up to two default
next hops to achieve load sharing.
Configuring PBR
Configuring local PBR
Configure PBR by applying a policy locally. PBR uses the policy to guide the forwarding of locally
generated packets.