F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

339
Task Remarks
Configuring path MTU
discovery
Configuring the interface MTU Optional.
Configuring a static path MTU for a specified IPv6
address
Optional.
Configuring the aging time for dynamic path MTUs Optional.
Configuring IPv6 TCP properties Optional.
Configuring IPv6 FIB load sharing Optional.
Configuring ICMPv6 packet
sending
Configuring the maximum ICMPv6 error packets sent
in an inter
val
Optional.
Enabling replying to multicast echo requests Optional.
Enabling sending ICMPv6 time exceeded messages Optional.
Enabling sending ICMPv6 destination unreachable
messages
Optional.
Enabling sending ICMPv6 redirect messages Optional.
Assigning IPv6 addresses to interfaces
This section describes how to configure an IPv6 global unicast address, an IPv6 link-local address, and
an IPv6 anycast address.
NOTE:
Before you modify the existing IPv6 address of an interface for an IPv6 address in the same network
segment as the interface, remove the existing address and reconfigure a new one. Otherwise, address
conflict may lead to an address modification failure.
Enabling IPv6
Enable IPv6 before you perform any IPv6-related configuration. Without IPv6 enabled, an interface
cannot forward IPv6 packets even if it has an IPv6 address configured.
To enable IPv6:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable IPv6.
ipv6 Disabled by default.
Configuring an IPv6 global unicast address
Configure an IPv6 global unicast address by using the following options:
• EUI-64 IPv6 addressing—The IPv6 address prefix of an interface is manually configured, and the
interface identifier is generated automatically by the interface.
• Manual configuration—The IPv6 global unicast address is configured manually.