F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

363
Configuration procedure
# Configure a mapping between host name host.com and IPv6 address 1::2.
<LB> system-view
[LB] ipv6 host host.com 1::2
# Enable IPv6.
[LB] ipv6
# Use the ping ipv6 host.com command to verify that LB can use static domain name resolution to resolve
domain name host.com into IPv6 address 1::2.
[LB] ping ipv6 host.com
PING host.com (1::2):
56 data bytes, press CTRL_C to break
Reply from 1::2
bytes=56 Sequence=1 hop limit=128 time = 3 ms
Reply from 1::2
bytes=56 Sequence=2 hop limit=128 time = 1 ms
Reply from 1::2
bytes=56 Sequence=3 hop limit=128 time = 1 ms
Reply from 1::2
bytes=56 Sequence=4 hop limit=128 time = 2 ms
Reply from 1::2
bytes=56 Sequence=5 hop limit=128 time = 2 ms
--- host.com ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 1/1/3 ms
Dynamic domain name resolution configuration
example
Network requirements
As shown in Figure 194, LB wants to access the host by using an easy-to-remember domain name rather
than an IPv6 address. The IPv6 address of the DNS server is 2::2/64 and the server has a com domain,
which stores the mapping between domain name host and IPv6 address 1::1/64.
Configure dynamic domain name resolution and the domain name suffix com on LB that serves as a DNS
client so that LB can use domain name host to access the host with the domain name host.com and the
IPv6 address 1::1/64.