F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

374
• Configure an IP address for each interface, and make sure all nodes are reachable to one another.
Configuration procedure
To configure the basic RIPng functions:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Create a RIPng process and
enter RIPng view.
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
Not created by default.
3. Return to system view.
quit N/A
4. Enter interface view.
interface interface-type
interface-number
N/A
5. Enable RIPng on the interface.
ripng process-id enable Disabled by default.
NOTE:
If RIPng is not enabled on an interface, the interface does not send or receive any RIPng route.
Configuring RIPng route control
Before you configure RIPng, complete the following tasks:
• Configure an IPv6 address on each interface, and make sure all nodes are reachable to one
another.
• Configure RIPng basic functions.
• Define an IPv6 ACL before using it for route filtering. For related information, see Security
Configuration Guide.
• Define an IPv6 address prefix list before using it for route filtering. For related information, see
"Configuring routing policies".
Configuring an additional routing metric
An additional routing metric can be added to the metric of an inbound or outbound RIP route.
The outbound additional metric is added to the metric of a sent route. The route's metric in the routing
table is not changed.
The inbound additional metric is added to the metric of a received route before the route is added into
the routing table, so the route's metric is changed.
To configure an inbound or outbound additional routing metric:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Specify an inbound routing
additional metric.
ripng metricin value
Optional.
0 by default.