F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

377
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter RIPng view.
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure RIPng
timers.
timers { garbage-collect
garbage-collect-value | suppress
suppress-value | timeout
timeout-value | update
update-value } *
Optional.
The RIPng timers have the following
defaults:
• Update timer—30 seconds.
• Timeout timer—180 seconds.
• Suppress timer—20 seconds.
• Garbage-collect timer—20 seconds.
Configuring split horizon and poison reverse
If both split horizon and poison reverse are configured, only the poison reverse function takes effect.
Configuring split horizon
The split horizon function disables a route learned from an interface from being advertised through the
same interface to prevent routing loops between neighbors.
HP recommends enabling split horizon to prevent routing loops.
To configure split horizon:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable the split horizon
function.
ripng split-horizon
Optional.
Enabled by default.
Configuring the poison reverse function
The poison reverse function enables a route learned from an interface to be advertised through the
interface. However, the metric of the route is set to 16, which means the route is unreachable.
To configure poison reverse:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable the poison reverse
function.
ripng poison-reverse Disabled by default.