F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

392
Ste
p
Command Remarks
7. Configure the LSA
transmission delay.
ospfv3 trans-delay seconds
[ instance instance-id ]
Optional.
By default, the LSA transmission
delay is 1 second.
8. Return to system view. quit N/A
9. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
10. Configure the SPF timers.
spf timers delay-interval
hold-interval
Optional.
By default, delay-interval is 5
seconds, and hold-interval is 10
seconds.
Setting both the delay-interval and
hold-interval to 0 triggers an SPF
calculation at once, improving the
network convergence speed.
Configuring a DR priority for an interface
The DR priority of an interface determines the interface's qualification in DR election. Interfaces having
the priority 0 cannot become a DR or BDR.
To configure a DR priority for an interface:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Configure a DR priority.
ospfv3 dr-priority priority [ instance instance-id ]
Optional.
Defaults to 1.
Ignoring MTU check for DD packets
When LSAs are few in DD packets, it is unnecessary to check the MTU in DD packets to improve
efficiency.
To ignore MTU check for DD packets:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Ignore MTU check for DD
packets.
ospfv3 mtu-ignore [ instance
instance-id ]
Not ignored by default.