F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

ManualsBrandsHP ManualsComputer AccessoriesHP 7100/7200 IPsec dl Module

402

Figure 204 Network diagram

Configuration procedure

1. Configure IPv6 addresses for interfaces. (Details not shown.)

2. Configure OSPFv3 basic functions:

# Enable OSPFv3 process 1 on Router A.

<RouterA> system-view

[RouterA] ipv6

[RouterA] ospfv3 1

[RouterA-ospfv3-1] router-id 1.1.1.1

[RouterA-ospfv3-1] quit

[RouterA] interface gigabitethernet 0/2

[RouterA-GigabitEthernet0/2] ospfv3 1 area 2

[RouterA-GigabitEthernet0/2] quit

[RouterA] interface gigabitethernet 0/1

[RouterA-GigabitEthernet0/1] ospfv3 1 area 2

[RouterA-GigabitEthernet0/1] quit

# Enable OSPFv3 process 1 and OSPFv3 process 2 on LB.

<LB> system-view

[LB] ipv6

[LB] ospfv3 1

[LB-ospfv3-1] router-id 2.2.2.2

[LB-ospfv3-1] quit

[LB] interface gigabitethernet 0/2

[LB-GigabitEthernet0/2] ospfv3 1 area 2

[LB-GigabitEthernet0/2] quit

[LB] ospfv3 2

[LB-ospfv3-2] router-id 3.3.3.3

[LB-ospfv3-2] quit

[LB] interface gigabitethernet 0/1

[LB-GigabitEthernet0/1] ospfv3 2 area 2

[LB-GigabitEthernet0/1] quit

# Enable OSPFv3 process 2 on Router B.

<RouterB> system-view

[RouterB] ipv6

[RouterB] ospfv3 2

[RouterB-ospfv3-2] router-id 4.4.4.4

[RouterB-ospfv3-2] quit