F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

414
IGP route with the same destination network segment before it can advertise the IBGP route (use the
display ipv6 routing-table protocol command to check the IGP route state).
To configure IPv6 BGP and IGP route synchronization:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family view.
ipv6-family N/A
4. Enable route synchronization between
IPv6 BGP and IGP.
synchronization Not enabled by default.
Configuring route dampening
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Configure IPv6 BGP route
dampening parameters.
dampening [ half-life-reachable
half-life-unreachable reuse suppress ceiling |
route-policy route-policy-name ]*
Optional.
Not configured by
default.
Configuring IPv6 BGP route attributes
This section describes how to use IPv6 BGP route attributes to modify BGP routing policy. The attributes
include the following:
• IPv6 BGP protocol preference
• Default LOCAL_PREF attribute
• MED attribute
• NEXT_HOP attribute
• AS_PATH attribute
Configuration prerequisites
Before you configure IPv6 BGP route attributes, complete the following tasks:
• Enable IPv6 function.
• Configure IPv6 BGP basic functions.