F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

418
Ste
p
Command Remarks
5. Configure the interval for
sending the same update to
an IPv6 peer or peer group.
peer { ipv6-group-name | ipv6-address }
route-update-interval interval
Optional.
The interval for sending the
same update to an IBGP peer
or an EBGP peer defaults to
15 seconds or 30 seconds.
Configuring IPv6 BGP soft reset
Enabling route refresh
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address
family view.
ipv6-family N/A
4. Enable route refresh.
peer { ipv6-group-name | ipv6-address }
capability-advertise route-refresh
Optional.
Enabled by default.
Performing manual soft-reset
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Save all routes from an IPv6
peer or peer group, not letting
them go through the inbound
policy.
peer { ipv6-group-name | ipv6-address }
keep-all-routes
Optional.
Not saved by default.
5. Return to user view.
return N/A
6. Soft-reset BGP connections
manually.
refresh bgp ipv6 { all | ipv6-address | group
ipv6-group-name | external | internal } { export
| import }
N/A
NOTE:
If the peer keep-all-routes command is used, all routes from the peer or peer group are saved re
g
ardless
of whether the filtering policy is available. These routes will be used to generate IPv6 BGP routes after
soft-reset is performed.
Enabling the IPv6 BGP ORF capability
The BGP Outbound Route Filter (ORF) feature allows a BGP speaker to send its BGP peer a set of ORFs
through route-refresh messages. The peer then applies the ORFs, in addition to its local routing policies