F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101
423
Ste
p
Command
Remarks
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Advertise COMMUNITY
attribute to an IPv6 peer or
peer group.
peer { ipv6-group-name |
ipv6-address }
advertise-community
Not advertised by default.
5. Advertise extended
community attribute to an IPv6
peer or peer group.
peer { ipv6-group-name |
ipv6-address }
advertise-ext-community
Not advertised by default.
Applying a routing policy to routes advertised to a peer or peer group
When configuring IPv6 BGP community, you must configure a routing policy to define the COMMUNITY
attribute, and apply the routing policy to route advertisement.
For routing policy configuration, see "Configuring routing policies."
To apply a routing policy to routes advertised to a peer or peer group:
Ste
p
Command
Remarks
1. Enter system view. system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Apply a routing policy to
routes advertised to an IPv6
peer or peer group.
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name export
Not applied by default.
Configuring an IPv6 BGP route reflector
In general, because the route reflector forwards routing information between clients, you are not required
to make clients of a route reflector fully meshed. If clients are fully meshed, HP recommends disabling
route reflection between clients to reduce routing costs.
If a cluster has multiple route reflectors, you must specify the same cluster ID for these route reflectors to
avoid routing loops.
To configure an IPv6 BGP route reflector:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Configure the router as a route
reflector and specify an IPv6
peer or peer group as a client.
peer { ipv6-group-name |
ipv6-address } reflect-client
Not configured by default.
5. Enable route reflection
between clients.
reflect between-clients
Optional.
Enabled by default.