F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

437

Figure 208 Network diagram

Configuration procedure

1. Configure LB:

# Configure RIPng.

<LB> system-view

[LB] ipv6

[LB] ripng 1

[LB-ripng-1] quit

[LB] interface gigabitethernet 0/1

[LB-GigabitEthernet0/1] ipv6 address 1::1 64

[LB-GigabitEthernet0/1] ripng 1 enable

[LB-GigabitEthernet0/1] quit

[LB] interface gigabitethernet0/2

[LB-GigabitEthernet0/2] ipv6 address 2::1 64

[LB-GigabitEthernet0/2] ripng 1 enable

[LB-GigabitEthernet0/2] quit

# Configure ACL 3001 to match TCP packets.

[LB] acl ipv6 number 3001

[LB-acl6-adv-3001] rule permit tcp

[LB-acl6-adv-3001] quit

# Configure Node 5 for policy aaa to forward TCP packets via GigabitEthernet 0/1.

[LB] ipv6 policy-based-route aaa permit node 5

[LB-pbr6-aaa-5] if-match acl6 3001

[LB-pbr6-aaa-5] apply ipv6-address next-hop 1::2

[LB-pbr6-aaa-5] quit

# Configure IPv6 interface PBR by applying the policy aaa on GigabitEthernet 0/3.

[LB] interface gigabitethernet 0/3