F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

451
[Router-GigabitEthernet0/1] ipv6 address 10::2 32
# Enable RIPng on the interface.
[Router-GigabitEthernet0/1] ripng 1 enable
[Router-GigabitEthernet0/1] quit
# Enable RIPng.
[Router] ripng
# Display RIPng routing table information.
[Router-ripng-1] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::7D58:0:CA03:1 on GigabitEthernet0/1
Dest 10::/32,
via FE80::7D58:0:CA03:1, cost 1, tag 0, A, 18 Sec
Dest 20::/32,
via FE80::7D58:0:CA03:1, cost 1, tag 0, A, 8 Sec
Dest 40::/32,
via FE80::7D58:0:CA03:1, cost 1, tag 0, A, 3 Sec
Applying a routing policy to filter received BGP routes
Network requirements
• All the devices in Figure 211 run BGP. Router C establishes EBGP connections with Router A, Router
B, and LB.
• Configure a routing policy on LB to reject routes from AS 200.
Figure 211 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure BGP:
# Configure Router A.