F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

44
Actions Access Trunk H
y
brid
Incoming tagged
frame
• Receives the frame
if its VLAN ID is the
same as the PVID.
• Drops the frame if
its VLAN ID is
different from the
PVID.
• Receives the frame if its VLAN is permitted on the port.
• Drops the frame if its VLAN is not permitted on the port.
Outgoing frames
Removes the VLAN tag
and sends the frame.
• Removes the tag and
sends the frame if the
frame carries the PVID
tag and the port
belongs to the PVID.
• Sends the frame
without removing the
tag if its VLAN is
carried on the port but
is different from the
PVID.
Sends the frame if its VLAN is
permitted on the port. The
frame is sent with the VLAN
tag removed or intact
depending on your
configuration with the port
hybrid vlan command. This is
true of the PVID.
Protocols and standards
• IEEE 802.1Q, IEEE Standards for Local and Metropolitan Area Networks: Virtual Bridged Local
Area Networks
Configuring VLANs in the web interface
Recommended VLAN configuration procedure
Ste
p
Remarks
1. Creating a VLAN.
Required.
As the default VLAN, VLAN 1 cannot be created or removed. You
cannot manually create or remove VLANs reserved for special
purposes.
2. Modifying a VLAN.
Required.
Select either task.
Configure the untagged member ports and tagged member ports of
the VLAN, or remove ports from the VLAN.
3. Modifying a port.
Creating a VLAN
1. Select Network > VLAN from the navigation tree.
The page as shown in Figure 25 appears.