F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

60
Ste
p
Command Remarks
7. Configure the uplink port.
a. Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
b. Configure the port to
operate in promiscuous
mode in a specific VLAN:
port isolate-user-vlan
vlan-id promiscuous
By default, a port does not operate
in promiscuous mode in a VLAN.
8. Return to system view.
quit N/A
9. Assign the downlink port to
the specified secondary
VLANs.
a. Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
b. (Optional.) Configure the
link type of the port:
port link-type { access |
hybrid | trunk }
c. Assign the port to the
specified VLANs (use one
of the commands
depending on the link
type):
port access vlan vlan-id
Or
port trunk permit vlan
{ vlan-list | all }
Or
port hybrid vlan vlan-list
{ tagged | untagged }
N/A
10. Return to system view. quit N/A
11. Configure the downlink port.
a. Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
b. Configure the port to
operate in host mode:
port isolate-user-vlan host
By default, a port does not operate
in host mode.
12. Return to system view.
quit N/A
13. Associate the
isolate-user-VLAN with the
specified secondary VLANs.
isolate-user-vlan
isolate-user-vlan-id secondary
secondary-vlan-id [ to
secondary-vlan-id ]
By default, an isolate-user-VLAN is
not associated with secondary
VLANs.