F3215-HP Load Balancing Module Network Management Configuration Guide-6PW101

Configure VLAN 6 on LB B as an isolate-user-VLAN, assign uplink port GigabitEthernet 0/3 to VLAN 6,

and associate VLAN 6 with secondary VLANs VLAN 3 and VLAN 4. Assign GigabitEthernet 0/1 to

VLAN 3 and GigabitEthernet 0/2 to VLAN 4.

As far as the device is concerned, LB A has only VLAN 5 and LB B has only VLAN 6.

Figure 41 Network diagram

Configuration procedure

The following procedure provides only the details about the configuration on LB A and LB B.

1. Configure LB A:

# Configure the isolate-user-VLAN.

<LBA> system-view

[LBA] vlan 5

[LBA-vlan5] isolate-user-vlan enable

[LBA-vlan5] quit

# Create secondary VLANs.

[LBA] vlan 2 to 3

# Configure uplink port GigabitEthernet 0/3.

[LBA] interface gigabitethernet 0/3

[LBA-GigabitEthernet0/3] port link-mode bridge

[LBA-GigabitEthernet0/3] port link-type hybrid

[LBA-GigabitEthernet0/3] port hybrid vlan 2 3 5 untagged

[LBA-GigabitEthernet0/3] port hybrid pvid vlan 5

[LBA-GigabitEthernet0/3] quit

# Configure downlink ports GigabitEthernet 0/1 and GigabitEthernet 0/2.

[LBA] interface gigabitethernet 0/1

[LBA-GigabitEthernet0/1] port link-mode bridge

[LBA-GigabitEthernet0/1] port link-type hybrid

[LBA-GigabitEthernet0/1] port hybrid vlan 3 5 untagged

[LBA-GigabitEthernet0/1] port hybrid pvid vlan 3

[LBA-GigabitEthernet0/1] quit

[LBA] interface gigabitethernet 0/2

[LBA-GigabitEthernet0/2] port link-mode bridge

[LBA-GigabitEthernet0/2] port link-type hybrid

[LBA-GigabitEthernet0/2] port hybrid vlan 2 5 untagged