F3215-HP Load Balancing Module Security Configuration Guide-6PW101

119
To enable the SSH server function:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the SSH server
function.
ssh server enable Disabled by default.
Enabling the SFTP server function
This SFTP server function enables clients to log in to the SFTP server through SFTP.
When the device functions as the SFTP server, only one client can access the SFTP server at one time and
the SFTP server does not have restrictions on the user privilege.
To enable the SFTP server function:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enable the SFTP server
function.
sftp server enable Disabled by default.
Configuring the user interfaces for SSH clients
An SSH client accesses the device through a VTY user interface. You must configure the user interfaces for
SSH clients to allow SSH login. The configuration takes effect only for the clients logging in after the
configuration.
IMPORTANT:
Before you configure a user interface to support SSH, you must configure its authentication mode to
scheme. Otherwise, the protocol inbound command fails.
To configure the user interface for SSH clients:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Enter VTY user interface view.
user-interface vty number
[ ending-number ]
N/A
3. Set the login authentication
mode to scheme.
authentication-mode scheme
By default, the authentication
mode is scheme.
For more information about this
command, see System
Management Command
Reference.