F3215-HP Load Balancing Module Security Configuration Guide-6PW101

167
2. Configure a static address mapping:
a. From the navigation tree, select Security > NAT Policy > Static NAT.
b. Click Add in the Static Address Mapping area.
c. Enter 1.1.1.1 for Internal IP Address and enter 2.2.2.3 for Global IP Address.
d. Click Apply.
Figure 68 Adding a static address mapping
3. Enable static NAT on GigabitEthernet 0/1:
a. Click Add in the Interface Static Translation area.
b. Select interface GigabitEthernet0/1.
c. Click Apply.
Figure 69 Enabling static NAT on an interface
4. Configure virtual fragment reassembly:
a. From the navigation tree, select Security > Virtual Reassembly.
b. Select Trust for Security Zone.
c. Select the Enable Virtual Fragment Reassembly box.
d. Click Apply.