F3215-HP Load Balancing Module Security Configuration Guide-6PW101

HWTACACS configuration task list

Task Remarks

Creating an HWTACACS scheme Required

Specifying the HWTACACS authentication servers Required

Specifying the HWTACACS authorization servers Optional

Specifying the HWTACACS accounting servers and the relevant parameters Optional

Specifying the shared keys for secure HWTACACS communication Required

Specifying a VPN for the HWTACACS scheme Optional

Setting the username format and traffic statistics units Optional

Specifying the source IP address for outgoing HWTACACS packets Optional

Setting HWTACACS timers Optional

Displaying and maintaining HWTACACS Optional

Creating an HWTACACS scheme

The HWTACACS protocol is configured on a per scheme basis. Before you perform other HWTACACS

configurations, create an HWTACACS scheme and enter HWTACACS scheme view. You can configure

up to 16 HWTACACS schemes.

To create an HWTACACS scheme and enter HWTACACS scheme view:

Ste

Command

Remarks

1. Enter system view. system-view N/A

2. Create an HWTACACS scheme and

enter HWTACACS scheme view.

hwtacacs scheme

hwtacacs-scheme-name

Not defined by default.

You can delete an HWTACACS scheme only when it is not referenced.

Specifying the HWTACACS authentication servers

You can specify one primary authentication server and one secondary authentication server for an

HWTACACS scheme. When the primary server is not available, the secondary server is used. If no

redundancy is needed, specify only the primary server.

An HWTACACS server can function as the primary authentication server of one scheme and as the

secondary authentication server of another scheme at the same time. You cannot specify the same IP

address as both the primary and the secondary authentication servers in a scheme.

To specify HWTACACS authentication servers for an HWTACACS scheme:

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enter HWTACACS scheme

view.

hwtacacs scheme

hwtacacs-scheme-name

N/A