F3215-HP Load Balancing Module System Maintenance Command Reference-6PW101

34
info-center source
Use info-center source to configure an information output rule for a module.
Use undo info-center source to remove the specified output rule.
Syntax
info-center source { module-name | default } channel { channel-number | channel-name } [ debug { level
severity | state state } * | log { level severity | state state } * | trap { level severity | state state } * ] *
undo info-center source { module-name | default } channel { channel-number | channel-name }
Default
The default output rules are listed in Table 11.
Views
System view
Default command level
2: System level
Parameters
module-name: Specifies a module. For instance, to output ARP information, specify this argument as ARP.
You can use the info-center source ? command to view the modules supported by the device.
default: Specifies all the modules, which can be displayed by using the info-center source ? command.
debug: Specifies debug information.
log: Specifies log information.
trap: Specifies trap information.
level severity: Specifies a severity level. For more information, see Table 5.
state stat
e: S
pecifies whether to output the specified system information, on (enabled) or off (disabled).
channel-number: Specifies a channel by its number in the range of 0 to 9.
channel-name: Specifies a channel by its name, a default name or a self-defined name. For information
about configuring a channel name, see info-center channel name.
Usage guidelines
This command sets an output rule for a specified module or all modules. For example, you can output IP
log information with a severity higher than warning to the log host, and output IP log information with a
severity higher than informational to the log buffer.
If you do not set an output rule for a module, the module uses the default output rule or the output rule set
by using the default keyword.
If you use the default keyword to set an output rule for all the modules without specifying the debug, log,
and trap keywords, the default output rules for the modules are used. See Table 11
for more information
a
bout default output rules.
If you use the module-name argument to set the output rule for a module without specifying the debug,
log, and trap keywords, the default settings for the module are as follows: the output of log and trap
information is enabled, with severity being informational. The output of debug information is disabled,
with severity being debug. For example, if you execute the command info-center source snmp channel 5,