F3215-HP Load Balancing Module System Maintenance Command Reference-6PW101

35
the command is actually equal to the command info-center source snmp channel 5 debug level
debugging state off log level informational state on trap level informational state on.
If you use the command multiple times, only the most recent output rule takes effect for the specified
module.
After you set an output rule for a module, you must use the module-name argument to modify or remove
the rule. A new output rule configured by using the default keyword does not take effect for the module.
The trap buffer only receives trap information and discards log and debug information.
The log buffer only receives log and debug information and discards trap information.
The SNMP module only receives trap information and discards log and debug information.
Table 11 Default output rules
Output
destinatio
n
Source
modules
Lo
g
Tra
p
Debu
g
Enabled/
disabled
Severity
Enabled/
disabled
Severity
Enabled/
disabled
Severity
Console
All
supported
modules
Enabled
Informatio
nal
Enabled Debug Enabled Debug
Monitor
terminal
All
supported
modules
Enabled
Informatio
nal
Enabled Debug Enabled Debug
Log host
All
supported
modules
Enabled
Informatio
nal
Enabled Debug Disabled Debug
Trap buffer
All
supported
modules
Disabled
Informatio
nal
Enabled
Informatio
nal
Disabled Debug
Log buffer
All
supported
modules
Enabled
Informatio
nal
Disabled Debug Disabled Debug
SNMP
module
All
supported
modules
Disabled Debug Enabled
Informatio
nal
Disabled Debug
Log file
All
supported
modules
Enabled Debug Enabled Debug Disabled Debug
Examples
# Output VLAN module's trap information with a severity level of at least emergency to the channel
console. All other system information cannot be output to this channel.
<Sysname> system-view
[Sysname] info-center source default channel console debug state off log state off trap
state off
[Sysname] info-center source vlan channel console trap level emergencies state on