F3215-HP Load Balancing Module System Maintenance Configuration Guide-6PW101

27
Task Command Remarks
Display a summary of the log
buffer.
display logbuffer summary [ level
severity ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display the content of the log file
buffer.
display logfile buffer [ | { begin |
exclude | include }
regular-expression ]
Available in any view.
Display the log file configuration.
display logfile summary [ | { begin
| exclude | include }
regular-expression ]
Available in any view.
Display the state and the trap
information of the trap buffer.
display trapbuffer [ reverse ] [ size
buffersize ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Clear the log buffer. reset logbuffer Available in user view.
Clear the trap buffer. reset trapbuffer Available in user view.
Information center configuration examples
Outputting log information to the console
Network requirements
Configure the LB to send ARP and IP log information that has a severity level of at least informational to
the console.
Figure 6 Network diagram
Configuration procedure
# Enable the information center.
<LB> system-view
[LB] info-center enable
# Use channel console to output log information to the console. (This step is optional because it is the
default setting.)
[LB] info-center console channel console
# Disable the output of log, trap, and debug information of all modules on channel console.
[LB] info-center source default channel console debug state off log state off trap state
off
To avoid output of unnecessary information, disable the output of log, trap, and debug information of all
modules on the specified channel (console in this example), and then configure the output rule as
needed.
# Configure an output rule to enable the LB to send ARP and IP log information that has a severity level
of at least informational to the console.